Wet Vacuum Operation - EWT CS 3 COMFORT Mode D'emploi

WET – VACUUM OPERATION
1
6
BEFORE YOU START
WARNING!
You must first read and understand the section on "precau
tions and guidelines regarding safety" and take them into
account.
Guidelines: Never vacuum dangerous substances.
1. Make sure the appliance is not plugged into the mains. Check that the container is clean and dust
free (Fig. 1).
2. Remove the dust bag and the reusable cloth filter. Leave only the foam filter on the filter housing.
Replace the upper part of the container and close the container clasps (Fig. 2).
DO NOT USE a dust filter for vacuuming liquids
3. Insert the largest end of the hosepipe into the suction port on the front of the container and lock it by
turning it to the right. Select the desired nozzle or the extension(s) and fit them onto the hosepipe (Fig. 3).
4. Make sure the Stop/Start switch on the appliance is in the "Stop" position ("O" position) before plugging
into the mains (Fig. 4).
5. Start the motor (Start/Stop switch in the "Start" position ("I" position) (Fig. 5).
When you have finished vacuuming, stop the motor by putting the Start/Stop switch in the "Stop"
position ("O" position). Unplug from the mains.
6. After use, empty the container and dry it.
IMPORTANT! If you wish to vacuum large quantities of liquid
from a sink, a tank or similar, do not place the whole of the
nozzle in the liquid, but leave a little room so that are can be
2 3
4
37
5