Wet Vacuum Operation - EWT CS 2 Mode D'emploi

OPERATION: DRY VACUUMING
1. Insert the largest end of the hosepipe into the suction port on the front of the container (Fig. 6) and
lock it by turning it to the right. Select the desired nozzle or extension(s) and fit them onto the
hosepipe. Make sure the Start/Stop switch on the appliance is in the "Stop" position ("O" position)
before plugging into the mains.
2. Plug it into the mains (Fig. 7).
3. Start the motor with the Start/Stop switch in the "Start" position ("I" position) (Fig.8).
4. When you have finished vacuuming, stop the motor by putting the Start/Stop switch in the "Stop"
position ("O" position). Unplug from the mains.
Check the dust bag regularly and replace it when it is 2/3 full. The bag is manufactured so that only air
may pass through the paper and not the dust, this is why a used dust bag should not be reused.
GUIDELINES: Do not use the dust bag to vacuum wet objects
or with sharp edges.
O = OFF
Optional Cartridge Filter
When using an optional cartridge filter, you should first remove the foam filter or the reusable cloth filter.
Insert the filter by the top in the filter housing and lock the base. After prolonged use it can be cleaned by
tapping it or by using a small brush.
WET – VACUUM OPERATION
1
6
I = ON
4
37
5