Maintenance - EWT CS 3 COMFORT Mode D'emploi

1
1. Verify that the power cable is disconnected from the outlet (Fig. 1).
2. Disconnect the hose from the container (Fig. 2).
3. Undo the clasps and remove the top section from the container (Fig. 3).
4. Clear all dirt or debris from the container and hose (Fig. 4).
5. Clean the foam filter or dust filter by washing it with a mild soapy solution (Fig. 5).
6. Check the float switch after removing the foam filter. To do this, take the upper part by the handle and
turn it over carefully so that the filter housing is turned upwards. The float switch should be able to
move freely up and down.
IMPORTANT! Clean or change the cloth filter regularly for best
performance. ALWAYS USE CLOTH FILTER FOR DRY
VACUUMING. If the machine is used without the cloth filter,
the motor will burn out and the warranty will be voided.
Always keep spare filters on-hand.
NOTICE! The filters included are made of high quality materials
designed to stop small dust particles. The cloth filter should be
used for dry pick-up only. A dry cloth filter is necessary to pick
up dust. If the cloth filter is wet, it will clog quickly and be very
difficult to clean. Handle the filter carefully when removing it for
cleaning and replacing it. Check the filters for tears or small holes,
a small hole can let dust pass through and out of the cleaner. Do
not use a filter with holes or tears, replace it immediately.
WARNING! ALWAYS DISCONNECT THE PLUG FROM THE
POWER OUTLET BEFORE REMOVING THE POWER HEAD
FROM CONTAINER.

MAINTENANCE

2 3
4
39
5