B Appendix - Flamepath - Videotec MAXIMUS MPXHD DELUX Manuel D'instructions

B Appendix - Flamepath

The maximum constructional gap (ic) is less than that required by Table 3 of EN 60079-1:2014 as detailed below:
FLAMEPATH
1. Between component drawings
BRT2MPXALBPAN-EX e BRT2MPXTAPINF-EX
2. Between component drawings
BRT2MPXALBTP-EX e BRT2MPXBUT-EX
3. Between component drawings
BRT2MPXALBTS-EX e BRT2MPXBUT-EX
4. Between component drawings
BRT2MPXALWIP-EX e BRT2MPXBUST-EX
Tab. 12
MNVCMPXHDB_1822_EN
MAXIMUM GAP (MM) MINIMUM WIDTH (MM)
0.249 25.4
0.245 26.8
0.245 26.8
0.249 25.3
COMMENT
Cylindrical joint sup-
ported by bearings
Cylindrical joint sup-
ported by bearings
Cylindrical joint sup-
ported by bearings
Cylindrical joint sup-
ported by bearings
45