Motor Type Selection (Dip Sw1 - Position 6) - Franklin Electric SUBDRIVE CONNECT 50 Manuel Du Propriétaire

Motor Type Selection (DIP SW1 – Position 6)
Use DIP SW1 Position 6 to select between a submersible or surface (centrifugal) pump.
Select the SUB (down) position for submersible applications. Then, use DIP SW2 and SW3 groups to select
motor and pump sizes.
Select the CEN (up) position for surface applications. When CEN is selected, DIP SW2 and SW3 groups are re-
purposed to configure surface pump parameters.
Submersible Motor and Pump Sizes (DIP SW2 & DIP SW3)
Select a single DIP switch from the SW2 group that corresponds to the motor horsepower being used. Use
the legend printed on the black shield as a guide.
Select a single DIP switch from the SW3 group that corresponds to the pump horsepower being used. Use
the legend printed on the black shield as a guide.
Selecting none or more than one switch in either group will result in an Invalid DIP Switch Fault, indicated by
F24 on the display.
Surface Motor Overload Size (DIP SW2 & DIP SW3)
When using a SubDrive in a surface application, and DIP SW1 Position 6 is set to CEN (up), select a single DIP
switch from the SW2 and SW3 groups that corresponds to an overload current value equal to or less than
the motor nameplate current rating. Use the following table, or the white legend on the shield, as a guide:
Max
Model
Current
SD 15 5.9
SD 20 8.1
SD 30 10.9
SD 50 17.8
Selecting none or more than one switch in either group will result in an Invalid DIP Switch Fault, indicated by
F24 on the display. More precise settings are available when using the FE Connect mobile app. Refer to
"Pump and Motor Settings" on page
SW2-1 SW2-2 SW2-3
100% 95% 90%
5.9 5.6 5.3
8.1 7.2 6.8
10.9 10.3 9.8
17.8 16.9 16.0
32.
Motor Type Selection (DIP SW1 – Position 6)
SW2-4 SW2-5 SW2-6
85% 80% 70%
5.0 4.7
5.9 4.7 4.0
9.2 8.7
15.1 14.2 12.4
DRIVE CONFIGURATION
SW3-1 SW3-2
50% 40%
4.1 2.9 2.3
3.6 3.0
7.6 5.4 4.3
8.9 7.1
25