Mounting The Drive; Drive Dimensions - Franklin Electric SUBDRIVE CONNECT 50 Manuel Du Propriétaire

PHYSICAL INSTALLATION

Mounting the Drive

Mounting the Drive
Risk of bodily injury or damage to drive or other equipment.
• The drive must be mounted on a structure such as a wall or post capable of supporting the weight of
the unit. Refer to "Specifications" on page 47
• Install VFD on a non-combustible surface.
• Ensure suitable mounting hardware is used when installing the drive.
• Do not install the drive on unreinforced drywall.
• Use two persons when lifting the drive for transport or installation. If using lifting equipment, it must
be in good condition and rated for at least 5 times the weight of the drive.
The mounting location should have nearby access to an appropriate electrical supply and to the motor wir-
ing. Refer to "Electrical Installation" on page
1. Mount the drive using the hanging tab on the top side of the enclosure.
2. Top screw should attach to a solid structure such as a stud or brace.
3. Secure the two (2) additional mounting holes on the back side.
4. All three (3) screw hole locations should be used to ensure the drive is securely mounted.
IMPORTANT: Do not drill holes in the drive.

Drive Dimensions

Model
SubDrive 15
464.2 mm
(18.28 in)
SubDrive 20
SubDrive 30 539.4 mm
(21.24 in)
SubDrive 50
539.4 mm
(21.24 in)
16
for drive weight.
17.
"A" "B"
355.2 mm
(13.98 in)
430.4 mm
(16.94 in)
430.4 mm
(16.94 in)
"C" "D"
454.7 mm 427.4 mm
(17.90 in) (16.83 in)
529.9 mm 502.6 mm
(20.86 in) (19.79 in)
529.9 mm 416.2 mm
(20.86 in) (16.39 in)
"E"
157.4 mm
(6.19 in)
157.4 mm
(6.19 in)
168.4 mm
(6.63 in)