How To Charge; How To Install The Battery - Segway B Serie Manuel De L'utilisateur

5. How to Charge

The battery level may be low or empty during transportation and storage. You can charge using any one
of the methods mentioned below. Remember to unplug from the power supply once fully charged.
1 Charge the Vehicle
Connect the battery power plug, then close the seat bucket. Connect the charger output to the vehicle
charging port, and then connect to the power outlet.
2 Internal Charging
Connect the charger output directly to the battery charging port, plug into the power outlet, and then close
the seat bucket.
3 Charge the Battery
Open the seat bucket and take out the battery. Connect the charger output to the battery charging port,
and then connect to the power outlet.
13
*The charger indicator is red when charging and turns to solid green when fully charged.
If the temperature of the vehicle body exceeds 104°F (40°C), it cannot be charged normally. Please wait for the temperature to drop.
WARNING
● ONLY use the original charger. Other types may explode and catch fire.
● DO NOT charge if the battery is wet or damaged.
● DO NOT connect the charger when the charging port or charging cable is wet.

6. How to Install the Battery

After charging the battery, please put it into the vehicle by following steps:
1 Open the seat bucket by any of the following methods.
Use the key.
If the battery is in , squeeze and hold any brake lever and hold the Auto key. If the battery is not in, press
and hold the Auto key, wait until the E, F, as well as the phone connection signal light up, and then squeeze
one brake lever while holding the Auto key.
*Please enable the AirLock in the app in advance. Make sure the ECU battery is not empty. You can check the battery level in
the app.
2 Put the battery in the vehicle, connect the battery power plug and close the saddle.
Squeeze hold one brake lever and tap the NFC card
on the dashboard.
14