Maintenance - Segway B Serie Manuel De L'utilisateur

8. Maintenance

Cleaning
Clean with water, neutral detergent and a soft cloth.
CAUTION
DO NOT clean with alcohol, gasoline, acetone, or other corrosive/volatile solvents. These substances may
damage the appearance and internal structure of your vehicle. DO NOT wash with a power washer or hose.
DO NOT rub with sandpaper or metal brush.
WARNING
Before cleaning, make sure the vehicle is powered off.
Storage
Store in a dry and cool place indoors and avoid sunlight and rain, so as not to rust parts and shorten the
service life. Disconnect the battery power plug for long-time storage to prevent over-discharge.
Motor
1. When riding in wet conditions, the water level should not exceed the central axis of the rear wheel.
2. Clean the vehicle after each ride to prevent particles from entering the motor and affecting its normal use.
Do not spray water directly when cleaning.
3. Check if there is abnormal noise when the motor is running.
Battery
1. DO NOT drain the battery. It is recommended to keep the battery level above 15%. Charge after each ride
to prolong the service life of the battery.
2. It is strictly prohibited to disassemble the battery. There is a danger of electric shock, short circuit, fire,
explosion, etc.
3. When the battery indicator bars are all lit up or the charger indicator turns green, it means the battery is
fully charged.
4. The storage temperature for the battery is 32–95°F (0–35°C).
17
5. If you are not going to use the vehicle for a long time, take out the battery after it is fully charged,
place in a dry and well-ventilated place, and charge it every two months.
6. DO NOT store the battery in a place where there is a risk of falling. Falling may cause battery damage,
short circuit, fire and explosion.
WARNING
DO NOT disassemble the battery. For information about the recycling and disposal of the battery and
electrical waste, please contact your household waste disposal service, your local or regional waste
management office, or your point-of-sale.
WARNING
- Risk of Fire - No user serviceable parts
Charger
● Before charging:
1. The charger should ONLY be used to charge the original vehicle/battery. It is strictly prohibited to charge
non-rechargeable batteries.
2. To prevent the electronic components inside the charger from loosening, DO NOT carry the charger in
the vehicle.
3. The power supply voltage should be 100–240V AC.
4. DO NOT use when there are broken cables or loose connectors.
● During charging:
1. Place the vehicle in a safe place away from rain and sun exposure.
2. Connect to the battery or vehicle charging port first, and then plug into the power supply.
3. When there is an abnormal smell, sound or light display, stop charging immediately and contact after-sales
service.
● After charging:
1. When the battery is full, disconnect from the power outlet first and then unplug the charger plug.
2. After the charger cools down, place it in a safe place inaccessible to children.
18