How To Charge; How To Install The Battery - Segway eMoped C80 Mode D'emploi

5. How to Charge

The battery level may be low or empty during transportation and storage. You can charge in any one of
the methods below. Remember to unplug from the power supply once fully charged.
1 Charge the Vehicle
Connect the battery power plug, then close the trunk. Connect the charger output to the vehicle charging
port, and then connect to the power outlet.
2 Internal Charging
Connect the charger output to the battery charging port, plug into the power outlet, and then close the trunk.
3 Charge the Battery
Open the trunk and take out the battery. Connect the charger output to the battery charging port, and
then connect to the power outlet.
*The charger indicator is red when charging and turns to solid green when fully charged.
If the temperature of the vehicle body exceeds 104°F (40°C), it cannot be charged normally. Please wait for the temperature
to drop.
09
Vehicle charging port
WARNING
● ONLY use the original charger. Other types can burst and catch fire.
● DO NOT charge if the battery is wet or damaged.
● DO NOT connect the charger when the charging port or charging cable is wet.

6. How to Install the Battery

After charging the battery, please put it into the vehicle in the following steps:
1 Open the trunk by any of the following methods.
Use the key.
If the battery is in the vehicle, squeeze one brake lever and hold the custom button. If the battery is not
in, press and hold the custom button, wait until the E, F, as well as the phone connection signal light up,
and then squeeze one brake lever while holding the custom button.
*Please enable the AirLock in the App in advance. Make sure the ECU battery is not empty. You can check the battery level
in the App.
2 Put the battery in the vehicle, connect the battery power plug and close the trunk.
Squeeze one brake lever and tap the NFC card on the
dashboard.
10