Connections And Controls - Bose L1 II Notice D'utilisation

English English Dansk Deutsch Español Dansk

Connections and controls

Figure 2
Power stand top panel
Power/Fault LED
Indicates power status.
Blue = system on
Red = system fault
AC Mains
AC power input 
connector.
Bass - Line Out
Post-DSP bass signal output.
Accepts a ¼" TRS phone cable.
Used to drive a PackLite
amplifier.
Analog Input
A line-level analog input. Accepts
a ¼" TRS phone cable. Used for
an instrument or other audio
source.
Français Deutsch Italiano Nederlands
The top panel of the power stand provides system connectors and controls (Figure 2).
® power
Signal/Clip LED
Indicates status of the analog input signal.
Green = normal input
Yellow = input approaching clipping
Red = input clipping
Español Français Svenska
Venice_Intro.fm 8/12
Italiano Nederlands
Power switch
Switches the system
on and off.
Bass Module Out
Bass output signal for driving one B2
or two B1 bass modules. Accepts a
4-wire bass module cable.
Trim
Adjusts the level of the
analog input signal.
ToneMatch
Digital audio and power con-
nection for the optional T1
ToneMatch audio engine. 
Accepts the included 
ToneMatch cable.
Svenska
I
NTRODUCTION
®
port
7