Setting Up The L1 ® Model Ii Power Stand; Assembling The L1 Model Ii Top And Bottom Array Loudspeakers - Bose L1 II Notice D'utilisation

Svenska Nederlands
S S
YSTEM ETUP
Setting up the L1
Figure 2
Putting the power stand on
the floor

Assembling the L1 model II top and bottom array loudspeakers

Figure 3
Setting up the L1 model II
top and bottom arrays
10
Italiano Français Svenska
®
model II power stand
1. Holding the power stand vertically on the floor (Figure 2A), grasp one leg and swing it out
as far as it will go. Notice that the other legs swing out automatically. 
The legs must be fully open before you can plug the L1
the power stand.
2. Lay the power stand flat on the floor in the desired position (Figure 2B).
A
Socket for
L1 bottom
WARNING: DO NOT move the completely assembled system as a unit. This could result in
personal injury and/or damage to the product. Position the power stand on the floor in the
chosen location before assembling the system.
This procedure tells you how to set up the loudspeaker sections in the power stand. If you
plan to mount the T1 ToneMatch
ToneMatch ® audio engine (optional)" on page 12 before installing the top section of the loud-
speaker.
1. Hold the L1 bottom so that the grille faces front and plug it into the power stand (Figure
3A). Be sure to fully insert it into the socket to assure stability and a good connection.
2. Align the bayonet on the L1 top with the channel on the back of the L1 bottom, and lower
the L1 top onto the L1 bottom until it is flush (Figure 3B).
A
Front of
system
Nederlands Español
®
audio engine on the L1 model II system, see "Adding a T1
B
L1 top
L1 bottom
Français Deutsch Italiano Deutsch Español Dansk
®
bottom section into
B
Bayonet
Channel
English English Dansk

