Operation; General Operation; Remote Operation - Dimplex XLF50 Manuel Du Propriétaire

Operation

General Operation

WARNING: This electric
firebox must be properly installed
before it is used.
This firebox operates with
Comfort$aver
TM
which automatically adjusts the
fan speed and heater wattage to
safely and precisely match the
requirements of the room based
on the thermostat setting. The
heater operates such that once
the room reaches the set point, the
fan and heater will continuously
run at a low level, to maintain
the desired room temperature.
If the temperature in the room
rises significantly, i.e. sun coming
through a window or a central
furnace turns on, the heater will
turn off and periodically turn back
on to circulate the air around the
unit, until the room temperature
drops and requires the heater to
be constantly on again.
! NOTE: The unit is designed so
that the fan will run continuously
while the heater is on.
! NOTE: The element retains
heat after shutdown. When the
heat is turned Off, there is a
2-minute cool down period before
the fan shuts off completely.
technology,

Remote Operation

The fireplace is supplied with an
IR multi-function remote control.
! NOTE: To operate correctly,
the remote control must be
pointed towards the front of the
unit.
Controls
The unit can be controlled by
either the manual controls which
are located on the upper right of
the fireplace or the remote
(Figure 9 and 10).
A. Standby
Turns the unit On and Off.
Activated by pressing the
Standby button on the remote
or the unit.
• The unit will turn On with the
same functions that it was set
to when it was turned Off and
the intake temperature will be
indicated on the Display.
! NOTE: When any button is
pressed on the unit the intake
temperature will be displayed on
the Display for 7 seconds.
15