Operation - Dimplex SIL48 Manuel D'instructions

Operation

The fireplace can be operated with the multi–function IR remote control or from the
touchscreen controls on the top-right of the front glass.
Once the fireplace is turned on the digital display and the control icons on the front
glass will illuminate. If no button or icon is pressed within 10 seconds, the fireplace
controls will deactivate by the digital display turning off first and then the icons. To
reactivate the controls press any button on the remote or touch any icon on the front
glass.
7
1. Power ON/OFF
2. Flame Control
3. Heat ON/OFF
4. Timer
5. Ember Bed
6. Level Selection
7. Digital Display
!
The heater on your fireplace may emit a slight, harmless odor when first
NOTE:
used. This odor is a normal condition caused by initial heating of internal heater
parts and will not occur again.
CUTOFF SWITCH
!
There is a safety temperature cutoff switch (cutout) inside the heater. If the
NOTE:
heater overheats, the cutout will shut off the supply power.
It can be reset by unplugging the unit and waiting 5 minutes before plugging the
unit back on.
If you need to continuously reset the heater, unplug the unit and call
CAUTION:
technical service at 1-888-346-7539.
16
7
1
2
1
3
2
4
3
5
4
6
5
6
Remote