ABUS Security-Center TV7218 Instructions D'installation page 65

Installation of the IR dome network camera
Proceed as follows when installing the camera.
1. Select a suitable place on the ceilling of the room where you would like to mount the camera.
2. Removing the housing cover of the camera by unscrewing
the cover screws with the supplied wrench.
3. Chose the cable lead-through you want (side or housing
bottom). Close the unused opening with the metal plug.
4. Connect the network cable to the network connector.
Connect all other necessary cables to the camera (e.g. test
monitor to the video output).
5. Connect a 12V power supply to the power input of the
camera.
6. Hold the camera at the location where you want to
mount it. Check the orientation and angle of the
camera.
7. Change the tilt of the camera module if necessary.
8. Select the desired image framing at the lens by setting
the zoom (only TV7219). Optimise the sharpness by
adjusting the focus at the lens (only TV7219).
9. Mount the camera to the wanted place and screw the
dome cover back to the camera.
7