Hardware Installation - ABUS Security-Center TV7218 Instructions D'installation

Hardware installation

To prevent the risk of electric shock, first connect the socket of the transformer to the security network
camera before inserting the transformer into the mains socket.
When the camera is switched on, it runs a self-test, and the Power/Activity LEDs flashes green and red. If
this self-test completes successfully, the LED flashes green and the IR dome network camera is ready for
you to enter an IP address. After you enter an IP address, the green LED flashes once every second. If the
self-test is not successful, the red LED flashes several times. For troubleshooting hints, see Appendix A.
Consult your dealer for the correct installation of peripheral devices.
The IR dome network camera is equipped via an I/O terminal block with a digital input and a relay for device
control. At Pin 1 and Pin 2, an external digital input signal can be processed, whereby the voltage state is
monitored in the start phase at LOW. The output (Pin 3 and Pin 4) can be used for switching external
devices on and off.
1 DI- INPUT (output status of DI is low)
2 DI+ INPUT (max. 50mA, 12V DC)
3 RELAY OUTPUT (output status open)
4 RELAY OUTPUT (max. 1A, 24V DC)
Make sure that all accessories and articles
listed above are present in the scope of
delivery. Depending on application, an Ethernet
cable may be required. This Ethernet cable
must meet the specifications of UTP Category
5 (CAT 5) and must not be longer than 100
meters.
6