Overview; General - TOOLCRAFT 1662632 Notice D'emploi

• Depressurize hoses before connecting / disconnecting from pneumatic wrench
and compressor.
• Hoses covered in grease or oil must be carefully cleaned with use of dry cotton
towel.
• The air hose must be long enough to reach the work area and allow free
movement while working.
• Air hoses must only be connected or disconnected from pneumatic wrench after
compressed air has been shut off. Do not stop supply of compressed air by
kinking a hose!
• After connecting the hose to a source of compressed air, test fire the hose to
remove any accumulated particles inside the hose all the while observing
necessary safety precautions.
• RISK OF ELECTRIC SHOCK! Air hoses must never touch or be routed nearby
live electric conductors.

7. Overview

a) General
A1
A2
A3
A4
26
A1 Anvil
A2 Hammer case
A5
A3 Trigger
A6
A4 Exhaust port
A5 Motor housing
A7
A6 Control valve dial
A7 Valve switch
A8
- F (forward)
- R (reverse)
A9
A8 Handle
A9 Air inlet bushing