Decommissioning And Storage; Decommissioning; Storage; Maintenance & Cleaning - Gloria WEEDBRUSH Mode D'emploi

7

Decommissioning

& Storage
7.1 Decommissioning
Figure 15
Take the device out of operation by
releasing the ON/OFF safety switch (D)
in the handle.
Disconnect the device from the power
supply.
CAUTION! RISK OF INJURY FROM
RUNNING BRUSHING TOOL!
Never lift the device off the ground
whilst switching it off as there is
danger of entanglement!
Do not put the device down on the
15
brush during work breaks or after use
as this will damage the wire bristles.
Always hang the device up or lie it
down as shown in the illustration.

7.2 Storage

CAUTION! You may be exposed to
hazards that could injure you
when handling the device.
You must therefore store the
device away from children.
Remove any dirt and debris.
Store the device hung up, dry and
protected from frost.
8 Maintenance & Cleaning
CAUTION! RISK OF INJURY ON
SHARP-EDGED OR POINTED
DEVICE PARTS!
During assembly or conversion
work, you may injure yourself on
the joint brush's worn wires. It is
therefore important to observe
the following safety instruction:
Wear protective gloves during
assembly!

8.1 Cleaning

WARNING! RISK OF DEATH
DUE TO ELECTRIC SHOCK!
If the energised device comes into
contact with water, there is a risk of
seri ous injury or death!
You should therefore observe the
following safety instructions:
Switch off the device and disconnect
the power cord (C) from the power
supply.
Do not immerse the device in water
or spray or clean it with water.
The device must be protected
against moisture.
However, if the device does fall into
water, immediately unplug the
mains plug. Never reach into the
water if the device is still connected!
Clean the outside of the device with a
damp cloth or soft brush. Do not use
abrasives or harsh cleaning agents.
Ensure that the ventilation slots are
free of dirt.
In cases of heavier soiling of the joint
brush, clean the brushes in water or
with a strong water jet and a hard
brush.
Only use original GLORIA spare parts
for repairs.
Repairs must be carried out by a
GLORIA service point.

8.2 Wear of the brushes

NOTE!
If the joint brush wears down to a
diameter of ø approx. 90 mm, it must
be replaced.
22