Decommissioning And Storage; Decommissioning; Storage; Maintenance & Cleaning - Gloria MultiBrush Mode D'emploi

Unscrew the hexagon socket screw
24
2-3 turns so far out of the joint brush
housing, until safety guard (H) can
easily be twisted and pulled off.
Now press lock button (Q) which
25
blocks the drive shaft and unscrew the
hexagon socket screw, which fixes the
joint brush (J), from the drive shaft.
Remove the disc from the joint brush.
ATTENTION! Improper use
of the device poses a risk of
damage to property! You
should therefore observe the
following safety instructions:
Never activate the lock button (Q)
when the joint brush is running.
Pull the joint brush (J) from the flange
26
on the shaft and exchange it for a new
one.
Assembly is carried out in reverse
order.
After maintenance or cleaning ensure
that all screws, bolts, nuts and safety
devices are secure and assembled.
7

Decommissioning

& Storage
7.1 Decommissioning
Figure 27
Take the device out of operation by
releasing the ON/OFF safety switch (D)
in the handle.
Disconnect the device from the power
supply.
CAUTION! RISK OF INJURY FROM
RUNNING BRUSHING TOOL!
Never lift the device off the ground
whilst switching it off as there is
danger of entanglement!
Do not put the device down on the
27
brush during work breaks or after use
as this will damage the bristles. Always
hang the device up or lie it down as
shown in the illustration.

7.2 Storage

CAUTION! You may be exposed to
hazards that could injure you when
handling the device. You must there-
fore store the device away from chil-
dren.
Remove any dirt and debris.
Store the device hung up, dry and pro-
tected from frost.
8 Maintenance & Cleaning
CAUTION! RISK OF BURNS
CAUSED BY HOT PARTS!
During assembly or conversion work
the drive parts of the device or
components can still be very hot and
may cause burns. It is therefore
important to observe the following
safety instructions:
Wear protective gloves during main-
tenance and cleaning!

8.1 Cleaning

WARNING! RISK OF DEATH
DUE TO ELECTRIC SHOCK!
If the energised device comes into con-
tact with water, there is a risk of seri -
ous injury or death! You should there-
fore observe the following safety
instructions:
Switch off the device and disconnect
the power cord (C) from the power
supply.
29