Emptying And Service; Spare Parts - Gloria FoodMaster F12 Mode D'emploi

FOOD F12_980000-01.qxp_Innenseiten_FOOD F12.qxd 20.09.18 10:48 Seite 15
l
Screw valve body (B) back in and pump up
the device. Observe the safety / pressure
relief valve (A) during pumping. Peak pres-
sure is reached when the safety / pressure
relief valve is triggered. Any excess pres-
sure will escape through the safety / pres-
sure relief valve.
l
The spraying process is initiated by press-
ing the push button (F) on the valve body.
Releasing the push button (F) immediately
interrupts the spraying process.
l
Pump up the unit again once the pressure
has dropped to around 1.5 bar so as to en-
sure a con sistent distribution of the
sprayed liquid.

Emptying and Service

l
Any residual pressure in the tank can be
vented by lifting up the knob on the safety /
pressure relief valve (A). The safety / pres-
sure relief valve can only be actuated with
the device standing upright.
l
Unscrew the pomp carefully, at first only a
few turns by left-hand rotation, so that com-
pressed air being still in the tank can escape.
Only then unscrew the pump completely
and take it out of the tank.
l
Empty and wash out the unit after use.
Note!Any remaining liquid in the tank
can be emptied out completely through
the filler opening. The type of flushing
liquid to be used and how it is to be dis-
posed of will depend on the details given
by the manufacturer of the liquid to be
sprayed. Also consider whether the tank
is resistant to the flushing liquid.
l
Clean the device thoroughly, before filling
with food. Proceed as shown in Figures
1 - 8 on pages 4 - 5.
l
The pump will last much longer if the
pump O-ring (E)is lubricated from time to
time with a little re si n- and acid-free
grease.
WARNING! Lubricate only with grease
which is food safe.
Note!Above-average use due to manner
of operating (including the tranport to
the place of operation and the storage
when not using the sprayer), influences
of the surroundings (of the place of oper-
ation and the storage place), inadequate
maintenance and care may lead to an
early wear of the sprayer. Therefore, the
sprayer should be checked for secure and
serviceable state before use. It should at
least be checked for externally visible
damages.
Expecially when there occure damages
which endager the security, at least how-
ever after 2 years, the sprayer should spe-
cially be examined by one of the manu-
facturer's service stations.

Spare parts

728961.0000 . . . . . . . . . . . . . . . . . . Set of seals
15
GB
N