Commissioning; Operation - Gloria WEEDBRUSH Mode D'emploi

Now tighten the screw connection
(F) by hand by turning it clockwise.
As the device should always be
guided and operated with two
hands, fit the additional handle (E) as
shown in the figure
height and screw the additional
handle (E) tightly into place
6

Commissioning

WARNING! BEFORE USE OBSERVE
CHAPTER 2 "FOR YOUR SAFETY".
Observe the following safety
instructions:
Clean the joint brush (K) before
starting to work.
The air inlet openings on the
motor/gear unit (I) must not be
blocked or covered.
Check on a small, if possible hidden
area, that the ground to be cleaned
will not be damaged by the brush-
ing action.
Never use the device too long on
one spot, always guide at walking
pace.

6.1 Operation

Figures 5 - 9
Slide the loop of the extension cable
5
into the designated cable strain relief
(B) in the handle (A) and fix it in the
designated clip.
NOTE!
The performance of the equipment
may decrease if unnecessarily long
extension cables (>25 m) are used.
If cable reels are used, unroll the
en tire cable.
The cross-section of the cable used
must be al least 1.5 mm
, adjust the
3
.
4
.
2
20 20
Then adjust the 5 click-stop safety
6
guard (L) so that the rubber lip is just
above the ground.
Use an extension cable to connect the
7
device to a power outlet (230 V AC).
CAUTION! RISK OF INJURY FROM
ROTATING BRUSHING TOOL!
Never start the device in a tilted
position!
Do not start or operate device if
bystanders are in the danger zone.
Never put your hands or feet near to
the rotating brushing equipment!
Never clean if others, in particular
children or animals, are in the area!
Never use the device in the rain.
Place the device parallel with the guid-
8
ing wheel and joint brush on the joint
to be treated. Hold the device at work-
ing angle and make sure that the rub-
ber lip on the safety guard (L) is just
above the ground, as illustrated
Make sure that the surface to be
cleaned is free from debris e.g. stones,
screws etc., which could be flung up.
Hold the device securely by the
9
handle (A) and additional handle (E)
and switch on the device by pressing
and holding the ON/OFF safety
switch (D) in handle (A).
In case of work interruptions or
danger, release the ON/OFF safety
switch (D) immediately.
NOTE!
To adjust the safety guard (L), turn the
5 click-stop safety guard to the posi-
tion, as illustrated
Align the joint brush with the centre of
the joint, walk at an even steady pace
and push the device in front of you.
Adapt your pace of work to the degree
of soiling.
.
6
.
6