User Information; Replacing The Joint Brush; Decommissioning And Storage; Decommissioning - Gloria MULTIBRUSH speedcontrol PLUS Mode D'emploi

RZ_MULTIBRUSH_SC_DE_GB_FR_NL_979646-00_Text_GB 23.10.21 12:03 Seite 28
24
Align the joint brush with the centre of
the joint, walk at an even steady pace and
push the device in front of you. Adapt
your pace of work to the degree of soiling.
NOTE!

Always work along the joint and hold
the device away from your body.

In cases of stubborn dirt you can move
the device backwards and forwards on
the spot (like a scrubber), until the
required result is achieved.
CAUTION
RISK OF INJURY FROM RUNNING
BRUSHING TOOL!

Never lift the device off the ground
whilst switched on during work as
there is danger of entanglement!

6.2 User information


Do not remove any wet weeds with the
device.

Never clean wood decks or wood
terraces with the joint brush.

Only clean joints that are intact.
Damaged or crumbling joints or joints
with cracks should not be cleaned with
the device.

Rinse the cleaned surfaces thoroughly
after cleaning.

Worn brushes i.e. frayed bristles
should be replaced in good time.

Switch off the device, before starting
with the next cleaning course (e.g.
wood decks).

6.3 Replacing the joint brush

Figures 25 - 29

Switch off the device and disconnect the
power cord (D) from the power supply.
25
Open the locking device (L)
joint brush unit (K), as shown in the
illustration, and remove the joint
brush unit.
26
Unscrew the hexagon socket screw
3-4 turns so far out of the joint brush
housing, until safety guard (I) can easi-
ly be twisted and pulled off.
27
Now press lock button (R) which blocks
the drive shaft and unscrew the hexagon
socket screw, which fixes the joint brush
(K), from the drive shaft (
Remove the disc from the joint brush.
ATTENTION
Improper use of the device poses a
risk of damage to property!
You should therefore observe the fol-
lowing safety instruction:

Never activate the lock button (R)
when the joint brush is running.
28
Pull the joint brush (K) from the flange
on the shaft and exchange it for a new
one.
29
Assembly is carried out in reverse order
( ).

After maintenance or cleaning ensure
that all screws, bolts, nuts and safety
devices are secure and assembled.
7

Decommissioning

& Storage
7.1 Decommissioning
Figure 30

Take the device out of operation by
releasing the ON/OFF safety switch (E)
in the handle.

Disconnect the device from the power
supply.
CAUTION
of the
RISK OF INJURY FROM RUNNING
BRUSHING TOOL!

Never lift the device off the ground
whilst switching it off as there is dan-
ger of entanglement!
28
).