Shutting Down; Emptying And Cleaning - Gloria 405T Mode D'emploi

RZ_HLSG_2015_Mehrsprachig.qxp_Text_GB HLSG 30.06.16 08:30 Seite 19
6.1.2 Venting the container, draining the water and filling with spraying agent
figures
ATTENTION
Activate the safety/vent valve – red button – until the device is depressurised.
Prior to filling the sprayer, observe the instructions relating to particular hazards (R-phras-
es/German Hazardous Substances Ordinance [GefStoffV]) and safety advice (S-
phrases/German Hazardous Substance Ordinance [GefStoffV]) that are provided on the
chemical containers according to regulations.
Observe max. fill level (see technical data). The regulations of the spraying agent manufac-
turer specify the correct dosage and concentration.
NOTE!
supplied should be used for pre-filtration, especially when spraying agents are applied and particularly
when powder-based concentrates are used.
ATTENTION
The following must be observed during use:
Ensure that the compressor boost pressure and/or compressed air supply does not exceed
max. 6 bar.
Prior to loading, ensure that the pump handle is engaged.
The max. permissible fill quantity must not be exceeded.
The check valve insert in the compressor connection must not be removed for the purpose of
loading the container.
6.2 Spraying >>
CAUTION
device and the spraying agents. You must therefore always comply with the safety instruc-
tions/safety measures in this user manual, as well as the following instructions:
The device must only be operated when suspended in a vertical or steep upright position.
Pressing the actuation lever down on the quick closure valve initiates the spraying process. This
can be interrupted immediately by releasing the actuation lever.
Optimum spray pressure for best possible distribution of the spray liquid is 2-6 bar.
The pumping procedure makes it possible to influence the spray pressure at the nozzle.
Perform re-pumping if the spray pressure falls.
7

Shutting down

7.1 Emptying and cleaning >>
Solvents
Gasoline
Oil
tion to the safety instructions in this manual. Observe applicable laws and the specifications
of the agent manufacturers when disposing of residual quantities.
12 –
17
>>
figure
15 Use the supplied filling strainer for filling the tank. The filling strainer
Certain versions of the device are equipped with a compressor connection.
figures
– 20
18
You may be exposed to hazards that could injure you when handling the
figures
CAUTION
Danger to health due to escaping spraying agents! Pay atten-
–
21
27
19
>>