ETNA A2127 Mode D'emploi page 41

Plug your oven into a standard household
socket. Make sure your oven is the only
appliance connected to the socket. If your oven does
not operate properly, unplug it from the electrical
socket and then plug it back in.
Fill a microwave safe container with
300 ml (1/2 pint) of water. Place on
the GLASS TRAY and close the oven door. If you
have any doubts about what type of container to
use please refer to page 69.
Open your oven door by pressing the DOOR OPEN
BUTTON. Place the ROTATING RING inside the oven and
place the GLASS TRAY on top.
Press the STOP
button, and
press the START
button six
times to set 3
minutes of
cooking time.
You will hear a BEEP each
time you press the button.
Your oven will start before
you have finished the sixth
press; don't worry this is
normal.
41
The DISPLAY will count down from 3 minutes.
When it reaches 0 it will sound BEEPS. Open
the oven door and test the temperature of the water. If
your oven is operating the water should be warm. Be
careful when removing the container it may be hot.
YOUR OVEN IS NOW INSTALLED
GB