KTM Power Parts 60712964044 Mode D'emploi page 17

- Remove screws .
- Take off the cover.
- Pull the throttle grip and accelerator position sensor from the handlebar.
- Remove the 6 marked cable ties.
- Position the accelerator position sensor and right heated grip
(scope of supply) on the handlebar.
Catch engages in driver
- Route the cable in the accelerator position sensor so it is not under
tension (as shown) and secure with a cable tie.
- Position the cover.
Ensure that the cable can neither be kinked or pinched!
- Mount original screws and tighten to 3.5 Nm.
- Position left heated grip
- Slightly raise the rubber grip.
- Tighten screw .
.
(scope of supply) on the handlebar.
17