Operating Instructions - Stihl FS 90 Notice D'emploi

2.
1.
Unhook the retainer on the transport
N
guard and swing outward
If a grass cutting blade 250 is fitted:
Fit the transport guard (1) to the
N
cutting attachment from below.
If a circular saw blade is fitted:
FS 90, FS 90 R
Fit the transport guard (2) to the
N
cutting attachment from below,
ensuring that the stop is centered in
the recess.
Hook the retainer onto the hook of
N
the transport guard

Operating Instructions

During break-in period
A factory-new machine should not be
run at high revs (full throttle off load) for
the first three tank fillings. This avoids
unnecessary high loads during the
break-in period. As all moving parts
have to bed in during the break-in
period, the frictional resistances in the
engine are greater during this period.
The engine develops its maximum
power after about 5 to 15 tank fillings.
During Operation
After a long period of full throttle
operation, allow the engine to run for a
short while at idle speed so that engine
heat can be dissipated by the flow of
cooling air. This protects engine-
mounted components (ignition,
carburetor) from thermal overload.
After Finishing Work
Storing for a short period: Wait for the
2.
engine to cool down. Empty the fuel tank
and keep the machine in a dry place,
well away from sources of ignition, until
you need it again. For longer out-of-
service periods – see "Storing the
Machine".
English
29