Technical Data; Safety Instructions; Basic Information Concerning Safety; Personal Safety - Hilti DX 76-PTR Mode D'emploi

Spall guard for magazine and single fastener
guides
DX 76 PTR test gauge
Additional piston
Slider repair set
Cartridge type
Extra heavy
Very heavy
Heavy
Light

4. Technical data

Right of technical changes reserved.
NOTE
*for trouble-free operation.
Tool
Weight with magazine
Dimensions (L × W × H)
Magazine capacity
Contact movement
Contact pressure
Ambient operating temperature range
Maximum average fastener driving frequency*

5. Safety instructions

5.1 Basic information concerning safety

In addition to the information relevant to safety
given in each of the sections of these operating
instructions, the following points must be strictly
observed at all times.

5.1.1 Personal safety

a) Stay alert, watch what you are doing and use
common sense when operating a direct fasten-
ing tool. Do not use tool while tired or under
the influence of drugs, alcohol or medication. A
moment of inattention while operating tools may
result in serious personal injury.
b) Avoid unfavorable body positions. Make sure
you work from a safe stance and stay in balance
at all times.
Printed: 07.07.2013 | Doc-Nr: PUB / 5069850 / 000 / 00
Ordering designation
6.8/18 M black
6.8/18 M red
6.8/18 M blue
6.8/18 M green
DX 76 PTR
4.37 kg
464 mm × 104 mm × 352 mm
10 fasteners
32 mm
90...130 N
-15...+50°C
600/h
c) Never point the tool toward yourself or other
persons.
d) Never press the nosepiece of the tool against
your hand or against any other part of your body
(or other person's hand or part of their body).
e) Keep other persons, especially children, away
from the area in which the work is being carried
out.
f) Keep the arms slightly bent while operating the
tool (do not straighten the arms).
5.1.2 Use and care of powder-actuated fastening
tools
a) Use the right tool for the job. Do not use the
tool for purposes for which it was not intended.
en
5