Ec Declaration Of Conformity; Confirmation Of Cip Testing; Health And Safety Of The Operator; Noise Information - Hilti DX 76-PTR Mode D'emploi

12. EC declaration of conformity

Designation:
Type:
Year of design:
We declare, on our sole responsibility, that this
product complies with the following directives and
standards: 2006/42/EC.

13. Confirmation of CIP testing

The Hilti DX 76 PTR has been system and type
tested. As a result, the tool bears the rectangular PTB
approval mark showing approval number S 816. Hilti
thus guarantees compliance with the approved type.

14. Health and safety of the operator

14.1 Noise information

Powder-actuated fastening tool
Type
Model
Caliber
Power regulation
Application
Noise values measured and declared in accordance with ISO 4871:1996
Noise (power) level, L
WA, 1S
Measurement uncertainty, K
Sound pressure level at the workplace (1000 fasten-
ings per day), L
pAeq
Measurement uncertainty, K
Sound pressure emission, L
Measurement uncertainty, K
Noise values were determined in accordance with the noise measurement instructions in EN 15895-1, based
on the EN ISO 3744:1995 and EN ISO 11204:1995 standards.
NOTE The noise emissions measured and the associated measurement uncertainty represent the upper limit
for the noise values to be expected during the measurements.
Variations in operating conditions may cause deviations from these emission values.
Printed: 07.07.2013 | Doc-Nr: PUB / 5069850 / 000 / 00
Powder-actuated
fastening tool
DX 76 PTR
2005
WA
pA
pC, peak
pC
Hilti Corporation
Norbert Wohlwend
Head of Quality & Processes Man-
agement
BU Direct Fastening
10 2010
Unacceptable defects or deficiencies, etc. determined
during use of the tool must be reported to the person
responsible at the approval authority (PTB) and to the
Office of the Permanent International Commission
(C.I.P.).
DX 76 PTR
Series
6.8/18 blue
4
Fastening to 8 mm steel (400 MPa) with X-ENP 19
L15MX
114 dB (A)
2 dB
94 dB (A)
2 dB
139 dB (C)
2 dB
en
Raimund Zaggl
Senior Vice President
BU Direct Fastening
10 2010
19