ESAB EPP-200 Manuel D'instructions page 93

SECTION 3 INSTALLATION
9. Connect input conductors to line (wall) disconnect.
10. Replace side panel. Replace only if all connections have made.
Output connections require this panel to be removed.
11. Connect the other end of work cable to workpiece or cutting table.
Connection must be made to a clean, exposed metal surface, free of
paint, rust, mill scale, etc.
Work ground to work piece
Work ground to cutting table
Electric Current Is Hazardous.
WARNING
It is important to have a good earth ground connected to the
workpiece or cutting table.
93