Maintenance And Repair - TTI PL-P Serie Manuel D'utilisation

DECV<n>
DECV<n>V
DELTAI<n> <nrf>
DELTAV<n>
<nrf>
DELTAI<n>?
DELTAV<n>?
INCI<n>
INCV<n>
INCV<n>V
OP<n> <nrf>
OPALL <nrf>
DAMPING<n>
<nrf>
LSR?
LSE <nrf>
LSE?
EER?
QER?
The Manufacturers or their agents overseas will provide repair for any unit developing a fault.
Where owners wish to undertake their own maintenance work, this should only be done by skilled
personnel in conjunction with the service manual which may be purchased directly from the
Manufacturers or their agents overseas.
Calibration
The equipment is so designed and constructed that re-calibration should be required only
infrequently. The Manufacturers will provide a re-calibration service, as will their agents overseas.
Where owners wish to carry out re-calibration themselves, this should only be done by skilled
personnel with access to precision equipment working in conjunction with the service manual
which may be purchased directly from the Manufacturers or their agents overseas.
Cleaning
If the PSU requires cleaning use a cloth that is only lightly dampened with water or a mild
detergent. Polish the display window with a soft dry cloth.
WARNING! TO AVOID ELECTRIC SHOCK, OR DAMAGE TO THE PSU, NEVER ALLOW
WATER TO GET INSIDE THE CASE. TO AVOID DAMAGE TO THE CASE OR DISPLAY
WINDOW NEVER CLEAN WITH SOLVENTS.
32
Decrement the output voltage of output <n> by the deltav value.
Decrement the output voltage of output <n> by the deltav value and verify.
Set delta Amps of output <n> to <nrf>.
Set delta voltage of output <n> to <nrf>.
Returns the delta current value of output <n> in Amps.
Returns the delta voltage value of output <n> in Volts.
Increment the set current of output <n> by the deltai value.
Increment the output voltage of output <n> by the deltav value.
Increment the output voltage of output <n> by the deltav value and verify.
Set the output <n> status ON or OFF.
Set the status of all outputs ON or OFF.
Sets the meter damping of output <n> to OFF or ON.
Returns the value in the Limit Event Status Register.
Set the Limit Event Status Enable Register to the value of <nrf>.
Returns the value in the Limit Event Status Enable Register.
Returns the value in the Execution Error Register.
Returns the value in the Query Error Register.

Maintenance and Repair