Other Commands - TTI PL-P Serie Manuel D'utilisation

QER?
Sequential command
Operation complete message generated immediately after <rmt> is sent.
Returns the value in the Query Error Register in <nr1> numeric format. The register is then
cleared. The syntax of the response is
On the serial interface the response is sent immediately if in non-addressable mode, or when
addressed to talk, if in addressable mode.
Remote Command Summary
Common Commands
∗CLS
∗ESE <nrf>
∗ESE?
∗ESR?
∗IDN?
∗IST?
∗LRN?
∗OPC
∗OPC?
∗PRE <nrf>
∗PRE?
∗RST
∗SRE <nrf>
∗SRE?
∗STB?
∗TST?
∗WAI

Other commands

V<n> <nrf>
V<n>V <nrf>
I<n> <nrf>
V<n>?
I<n>?
V<n>O?
I<n>O?
DECI<n>
<nr1><rmt>
Clear Status.
Set the Standard Event Status Enable Register to the value of
<nrf>.
Returns the value in the Standard Event Status Enable Register.
Returns the value in the Standard Event Status Register.
Returns the instrument identification.
Returns ist local message.
Returns the complete set up of the instrument.
Sets the Operation Complete bit in the Standard Event Status
Register.
Returns the Operation Complete status.
Set the Parallel Poll Enable Register to the value <nrf>.
Returns the value in the Parallel Poll Enable Register.
Resets the instrument.
Set the Service Request Enable Register to <nrf>.
Returns the value of the Service Request Enable Register.
Returns the value of the Status Byte Register.
Examine the state of the FLT bit in the Status byte register and
return the result.
Wait for operation complete true.
Set the output <n> voltage to <nrf>.
Set the output <n> voltage to <nrf> and verify.
Set current limit of output <n> to <nrf>.
Returns the set voltage of output <n> in Volts.
Returns the current limit of output <n> in Amps.
Reads and returns the output <n> voltage in Volts.
Reads and returns the output <n> current in Amps.
Decrement the set current of output <n> by the deltai value.
31