TTI PL-P Serie Manuel D'utilisation page 25

∗ESE?
Sequential command.
Operation complete message generated immediately after <rmt> is sent.
Returns the value in the Standard Event Status Enable Register in <nr1> numeric format. The
syntax of the response is
On the serial interface the response is sent immediately if in non-addressable mode, or when
addressed to talk, if in addressable mode.
Example. If the Standard Event Status Enable Register contains 01000001b the response
to ∗ESE? will be 65<rmt>.
∗ESR?
Sequential command.
Operation complete message generated immediately after <rmt> is sent.
Returns the value in the Standard Event Status Register in <nr1> numeric format. The register is
then cleared. The syntax of the response is
On the serial interface the response is sent immediately if in non-addressable mode, or when
addressed to talk, if in addressable mode.
Example. If the Standard Event Status Register contains 01000001b the response to
∗ESR? will be 65<rmt>.
∗IDN?
Sequential command.
Operation complete message generated immediately after <rmt> is sent.
Returns the instrument identification. The exact response is determined by the instrument
configuration and is of the form
where <NAME> is the manufacturer's name, <MODEL> defines the type of instrument and
<VERSION> is the revision level of the software installed.
On the serial interface the response is sent immediately if in non-addressable mode, or when
addressed to talk, if in addressable mode.
∗IST?
Sequential command.
Operation complete message generated immediately after <rmt> is sent.
Returns ist local message as defined by IEEE Std. 488.2. The syntax of the response is
if the local ist message false or
if the local ist message is true.
On the serial interface the response is sent immediately if in non-addressable mode, or when
addressed to talk, if in addressable mode.
<nr1><rmt>
<nr1><rmt>
<NAME>,<model>,0,<version><rmt>
0<rmt>
1<rmt>
23