Applying The 'Instructions In Brief'adhesive Plate; Payment Systems; Side Coin Slot Assembly Kit - Saeco BOX MONETIERA Instructions

English
- Refit the card support in its original position using the
two screws. Take care with the electronic signal cable
(Fig.12).
- Insert the power supply fastons into the interface card
(1) (Fig.13).
- Connect the electronic signal cable to the interface card
(Fig.13).
- Insert the coin box if necessary and close the side cover
with the wrench (Fig.14).
The box is ready to accept side coin slots, Saeco
cards or other MDB readers. To install the side coin
slot (optional) and/or the Saeco card (optional), refer
to chapter "Payment systems", which outlines the
procedure for installing them correctly.
Important
Saeco declines responsibility for damages to the coffee
ma chine and other objects and for personal injuries
caused by an incorrect installation of the payment sys-
tem; the re spon si bil i ty falls on the person who installed
the system.
5 – APPLYING THE
'INSTRUCTIONS IN BRIEF'
ADHESIVE
PLATE
To apply the adhesive plate follow the instructions below
(also included in the Coffee Machine Instructions and
Maintenance manual) (Fig. 15).
To apply the adhesive plate it is necessary to:
- remove the top cover by inserting the key in the appro-
priate lock;
- remove the coffee tank cover;
- remove the coffee beans;
- unfasten the 2 screws of the coffee tank;
- remove the coffee tank;
- apply the adhesive plate in the front inside the coffee
tank;
- place the coffee tank back;
- fasten the 2 screws of the coffee tank;
- reinsert the coffee beans;
- reinsert the coffee tank cover;
- reinsert the top cover and lock it.

6 - PAYMENT SYSTEMS

The appropriate template must be used in order to assemble
the payment system correctly.
24
The templates have been prepared for installation of a side
coin slot, the Saeco-Card payment system and can also
be adapted to other payment systems used on the vending
machine.
6.1

Side coin slot assembly kit

The assembly kit includes:
1. 1 side coin slot
2. 4 round head screws
3. 4 nuts and washers
(Fig.16)
6.1.1 Installation
Fasten the coin slot to the template using the screws, washers
and nuts provided as indicated in figure 17.
(Fig.17)
Connect the side coin slot to the interface card with the flat
cable provided with the box. To make the connection, use