Replacing The Battery; Disposal Of Old Electrical And Electronic Equipment - Geberit Bambini Manuel D'utilisation

Replacing the battery

When the battery is almost dead, the LED
will flash during flush actuation.
Prerequisite
– A replacement battery (Lithium 6 V CR-
P2) is available.
– The washbasin is empty.
1
Disconnect the IR sensor. → See
illustration sequence
the battery , page 44.
2
Remove the battery box from the
wall.
3
Open the battery box and remove
the dead batteries.
4
Insert new batteries and close the
battery box.
5
Mount the battery box on the wall.
6
Connect the IR sensor.
✓ The LED flashes 3 times and
then lights up for 15 seconds.
✓ The Geberit Bambini washbasin
tap is ready for operation.
7
Hold your hand under the Geberit
Bambini washbasin tap to test the
function.
Settings by skilled persons
Contact a skilled person if a malfunction
diagnosis is required.
9007203497796235-1 © 06-2018
968.598.00.0 (00)
Disposal
Constituents
This product meets the requirements of
Directive 2011/65/EU (RoHS) (restriction of
the use of certain hazardous substances in
electrical and electronic equipment).
Disposal of old electrical and
electronic equipment
Replacing
In accordance with Directive 2012/19/
EU (WEEE - Waste Electrical and
Electronic Equipment) manufacturers of
electrical equipment are obliged to take
back old equipment and to dispose of it
appropriately. The symbol indicates that the
product cannot be disposed of with non-
recyclable waste. Old equipment should be
returned directly to Geberit where it will be
disposed of appropriately. Addresses to
which equipment can be returned can be
requested from the relevant Geberit sales
company.
EN
19