IKA RET control /t Mode D'emploi page 40

RMP_CONT_X X=1;4
RMP_IN_X X=1;4
RMP_INX_y X=1;4
RMP_LOOP_RESET_X
X=1;4
RMP_LOOP_SET_X
X=1;4
RMP_OUT_X_yn X=1;4
hh:mm:ss
RMP_PAUSE_X X=1;4
RMP_RESET_X
RMP_START_X X=1;4
RMP_STOP_X X=1;4
START_X X=1;2;4;5;7
START_X X=16
(old function)
STATUS_X
STOP_X X=1;2;4;5;7
40
Continuaton of ramp function (After prior RMP_PAUSE_X).
Reading the real segment number of ramp. With ramp not started: 0
Reading the accumulated value and the ramp segment duration of ramp segment y.
Ending of ramp loop.
To work off the ramps in one loop.
Setting the accumulated value (n) and the ramp segment duration (hh:mm:ss) for ramp segment y.
Stopping the ramp function. Freezing of real rated value and real ramp segment time.
Switching off ramp functions and deleting of all set ramp segments
Starting the ramp function, beginning with ramp function No.1 (Only possible after prior START_X.
After RMP_STOP_X START_X is not necessary.
Switching off ramp function. Rated value = 0. (Ramp is maintained, that means, ramp can be restarted with
RMP_STARTX_X).
Starting the instrument's (remote) function.
Activation of the "watchdog" function. If no rated value is entered givenin the next 60 seconds, the heating is
switched off.
Display of status
1S: mode of operation A
2S: mode of operation B
3S: mode of operation C
S0: manual operation without fault
S1: Automatic operation Start (without fault)
S2: Automatic operation Stop (without fault)
<0: error code: (-1)
- 1: error 1
- ... (see table)
-31: error 31
-83: wrong parity
-84: unknown instruction
-85: wrong instruction sequence
-86: invalid rated value
-87: not sufficient storage space
Switching off the instrument - (remote) function.
Variables set with OUT_SP_X are maintained. Contains the instruction RMP_STOP.
REMOTE
REMOTE
022009