Dalla Corte mina Notice Pour L'utilisateur page 47

Starting and using
• At the end of the heating stage, the
• Immediately afterwards, the boiler starts to heat up and the
light starts blinking. Once the pre-set temperature has been
reached, the light will stop blinking.
• The brewing group can be used while boiler is still heating up.
Multi-function dial knob
By rotating the multi-function dial knob (M Pic.3) you can choose the
desired functions, and therefore every position of the dial knob will
switch on one of the six lights (
Functions in this manual will be referred to as
Self-acquired dose programming
Rotate the M dial knob and select the dose to be set, keep the M dial
knob pushed for at least 6 seconds. After 6 seconds, the selected L
function will blink slowly to signal the adjusting mode. If you push
the M dial knob, you start pouring and the related L light starts
blinking more quickly. The pouring ends when the M dial knob is
light will stop blinking.
to - if active).
- .
| 47