Dalla Corte mina Notice Pour L'utilisateur page 39

Setting up for installation
The machine shall be placed on a surface that provides secure
support.
When arranging the systems, a 10 x 10 cm hole (A Pic.1) shall be
made in the support panel so that machine can be connected with
the systems beneath the counter space (B Pic.1).
The machine must be connected exclusively to an appropriate cold
drinking water source, in compliance with national norms and rules.
The pressure of the incoming water must be between 0.1 and 0.6
MPa. If this requirement is not met, consult the manufacturer. A shut-
off tap must be installed between machine water hose and water
system to block water flow in case of necessity (1 Pic.1).
Connect the drain siphon (5 Pic.1) with a minimum diameter of 40
mm to the drain system of the place of installation.
Electrical connection can take place only when an RCD (Residual
Current Device) has been installed with a nominal differential current
that does not exceed 30 mA.
| 39