Installation Recommendations - Simu CENTRIS veoHz M Notice Originale

6- TUBE PREPARATION FOR A MOTOR WITH MOUNTING BY CLAMPING JAWS
Use the 5067504 template provided with the kit
a &  : Cable routing
 &  : Motor mounting
INSTALLATION OF A MOTOR WITH MOUNTING BY CLAMPING JAWS
7- CABLE ROUTING IN THE TUBE (ALL MODELS)
To use the clutch lever on the left, turn the motor over

Installation recommendations:

- Remove the sharp edges and burrs on the tube so as not to damage the cables.
- Cable outlet in alignment a (if the crown is on the left, cable outlet to the right or vice versa).
- The cables must not interfere with the winding of the apron.
- Always make a loop with the power cable to prevent water from entering the motor.
- Cables passing through a metal wall must be protected and insulated by a sleeve or duct.
- Tie up the cables to avoid any contact with moving parts.
- Provide adequate bend radius for the clutch cable (at least 150 mm) to prevent blockage.
- Mounting the clutch handle: Refer to the manual provided with the clutch kit.
- The power cable is not removable. If it is damaged, return the motor to the After Sales Department to avoid any danger.
0°
25°
0°
115°
0° 1 2
115°
Ø11 mm
2
1
2
a
1
3
4
2
0°
5
4
r = 150 mm min.
r
0°
25°
3 4
25°
Ø11 mm
5
6 mm
24 N.m
±2
4
3
3
8 mm
30 N.m
±3
5
a
Do not wind the
clutch cable
0°
EN
4/9