Antari HZ-500 Mode D'emploi page 10

Pin
1
2
3
DMX CONTROL OPERATION
HZ-500 has on-board DMX control and the addressing is via the LCD control panel. The
HZ-500 uses 1 channel to control on/off operation. The channel has a value range from 0 to 255. The
on/off function can also be programmed with a DMX controller or DMX control software used by lighting
and effects operator.
Channel A
251-255 = ON
0-250 = OFF
If the value of channel A is set between 0 and 250, the unit is off.
While the value is set between 251 and 255, the unit is on.
Note: Once DMX cable is connected to the unit, then the LCD control panel cannot be used.
Hazer Liquid
Antari HZL-1 haze liquid was designed for use with the Antari HZ-500. Antari HZL-1 is a non-toxic
solution that produces a pure, translucent haze with extremely long hang time and low moisture, perfect
for the HZ-500.
Important: Never mix oil-based and water-based hazer liquids. Before switching the kind of haze liquid
Function
Ground
Data-
Data+
10