Before Use - cecotec CONGA 2290 Manuel D'instructions

ENGLISH
9. Free-fall sensor
10. Main brush cover
11. Main brush
12. Left side wheel
13. Right side wheel
14. Optical sensor
Components
Wet&Dry tank
Fig. 3.
1. Water compartment
2. Dust compartment
Charging base
Fig. 4.
1. Signal transmission area
2. Charging terminal
3. Charge indicator
4. Cable slot
5. Charging terminal
Mop
Fig. 5.
1. Mop
2. Mop bracket
3. Velcro
4. Tab
Main brush
Brush made of silicone and bristles, designed to clean all types of surfaces.
Fig. 6.
Silicone brush
Special brush for pet hair.
Power adapter
Fig. 7.
Magnetic Strip
28
Fig. 8.
Use the magnetic strip provided to set up a Magnetic wall to delimit a certain zone, to which
the robot will not be able to access and clean. For example, place the magnetic strip from one
door's frame to the other in order to forbid the robot from crossing to a room.

3. BEFORE USE

Take the product out of the box and remove all packaging materials.
Make sure all parts and components are included and in good conditions. If any sign of visible
damage is observed, contact immediately with the official Technical Support Service of Cecotec.
Warnings:
Remove all objects around the robot such as clothing, papers, cables, curtains or other fragile
objects.
Fig. 9.
If the area to be cleaned has a balcony or stairs, a physical barrier must be placed in order to
prevent product damage and ensure safe operation.
Fig. 10.
4. INSTALLATION
Robot and charging base installation
Connect the charging base to a power supply and store the remaining cable. It is important to
store the remaining cable at the bottom of the charging base to avoid it from being dragged
and disconnected.
Fig. 11.
Place the charging base against the wall, leaving the safety distance indicated in the below
picture.
Fig. 12.
Note: Ensure a space of at least 1 m on both the left and right side of the charging base, and a
space of at least 2 m in front of it.
Warning: Do not expose the charging base to direct sun light.
Long press the power button for 3 seconds; when the light indicator turns on, place the robot
on the charging base.
Fig. 13.
Steady blue light: ON/operating
ENGLISH
29