Short Instructions - Benning PV 1-1 Guide Rapide

Measured value memory (200 display screens)
-Store
+
Reading out the measured value memory via the USB interface
Preset limiting values
V Limiting value of insulating resistance
ISO
Measuring range
Function
Setting the date and time
-key and then press simultaneously the
the
Auto
R -key to select a date field and time field
PE
-key and the -
Note:
Setting the Auto Power Off (APO, Auto-P Off)
Ω
-key and then press simultaneously the
NULL
Ω
the Auto - -
NULL
V -
ISO
BENNING PV 1-1
-
Radio connection to BENNING SUN 2 - wireless SUN link
Coupling with insolation/temperature measuring instrument BENNING SUN 2
2
Decoupling from insolation/temperature measuring instrument BENNING SUN 2
Range
Activating/deactivating the radio transmission of the BENNING SUN 2
R -key and
PE
2
Note:
Error codes
Error codes Remedy
R -key and
PE
5
Ω
-
NULL
-key and the -key of the
R Auto
PE
R -key and the Auto
PE
2
BENNING PV 1-1

Short Instructions

-
BENNING PV 1-1
Important information
Before using the BENNING PV 1-1 please read the detailed operat-
ing manual (http://tms.benning.de/pv1-1) carefully.
The BENNING PV 1-1 should only be used by suitably trained per-
sonnel.
The connection to the PV generator is made exclusively in accord-
ance with the connection figure of the operating manual.
Disconnect not required safety tests leads from the BENNING PV 1-1.
Before the measurement disconnected the PV array from the PV
inverter!
The PV string under test must not exceed the maximum open-cir-
cuit voltage of 1000 V, the maximum short-circuit current of 15 A
and the maximum DC power (P = Uoc x Isc) of 10 kW.
The measurements are to be carried out on the individual PV string!
It must be ensured that all switching devices and isolating devices
are open and that all PV strings are isolated from each other.
Only test a single PV string, never test multiple strings and beware
of parallel connections! High levels of capacitance within the circuit
under test can cause high currents to flow and may damage the test
instrument.
Non-observiance will result in damage to the BENNING PV 1-1!
-key of
Disconnect the BENNING PV 1-1 from the test sample directly after
the test.
Do not touch the measuring probes! During insulating resistance
measurements, high electric currents might be applied to the meas-
uring probes.
Do not touch any metal parts of the test object during measure-
ment.
The PV generator must be isolated from the electric power supply!
Neither the positive nor the negative pole of the PV generator must
be earthed!
Via the 4 mm safety test leads, voltage measurements on mains
supply circuits are possible. Via the 4 mm test sockets, the
BENNING PV 1-1 must be used only in electric circuits of overvolt-
age category III with max. 300 V AC/DC for phase-to-earth measure-
-
ments. For this please disconnect the PV 1-1 measuring leads from
the PV test sockets before measuring.
Before starting the unit, always check it for signs of damage. Do not
use a damaged BENNING PV 1-1!
Only use safety measuring leads, which are supplied with the
BENNING PV 1-1.
The BENNING PV 1-1 is intended for making measurements under
dry ambient conditions only.
6
BENNING PV 1-1
1