Rear Exit; Rear Exit Shield (For Rear Vent Only) - Napoleon B42NTR Instructions D'installation Et D'utilisation
Masquer les pouces
Voir aussi pour B42NTR:
- Instructions d'installation et d'opération (144 pages) ,
- Manuel d'installation et d'utilisation (148 pages)
Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
22
3.11
REAR EXIT
EN
FAILURE TO CREATE A SEAL TO THE FIREBOX WITH THE EXHAUST COLLAR ASSEMBLY WILL CAUSE
THE APPLIANCE TO FUNCTION IMPROPERLY AND CAN CAUSE INJURY OR PROPERTY DAMAGE.
A.
Remove the safety screen and glass front, refer
to " SAFETY SCREEN / DOOR REMOVAL AND
INSTALLATION" section.
B.
Remove the contents from the fi rebox and set aside, you
will need the exhaust fl ue collar from the top of the log
carton.
C.
To ease assembly, remove the four hex head screws
securing the defl ector from inside the top front of the fi rebox, refer to
Figure 1.
D.
Place the gasket (provided) over the 4" (102mm) fl ue collar assembly and
bend along perforation.
E.
From inside the fi rebox, insert the 4" (102mm) fl ue collar through the back
of the fi rebox. Install the rear exit shield onto the 4" (102mm) fl ue collar,
see "REAR EXIT SHIELD" section for installation instructions.
F.
Secure the fl ue collar assembly, gasket and rear exit shield using the four
hex head 3/8" thread cutting screws, refer to Figure 2. NOTE: Do not
overtighten. The gasket needs only to be snug against the fi rebox.
G.
Reattach the defl ector using the four screws and install the log set, glass
door and safety screen.
3.12
REAR EXIT SHIELD (FOR REAR VENT ONLY)
A.
Remove the safety barrier assembly and door from the appliance, refer to the "SAFETY SCREEN &
DOOR REMOVAL / INSTALLATION" section of the manual for detailed instructions.
B.
Loosen the two screws, that secure the exhaust plate, and slide the baffl e in place by sliding its
slotted openings behind the screwheads, tighten the two previously loosened screws. Refer to the
illustration below.
C.
Reinstall the door and safety barrier assembly on the appliance, refer to the "SAFETY SCREEN &
DOOR REMOVAL / INSTALLATION" section of the manual for detailed instructions.
NOTE: THIS SHIELD IS USED TO BLOCK THE VIEW THROUGH THE VENTING TO THE OUTDOORS.
W415-1293 / D / 09.12.16
WARNING
!
Fig. 1
DEFLECTOR
É
Fig. 2
Publicité
Chapitres
Table des Matières
Dépannage
