Log Placement - Napoleon B42NTR Instructions D'installation Et D'utilisation

6.3

LOG PLACEMENT

FAILURE TO POSITION THE LOGS IN ACCORDANCE WITH THESE DIAGRAMS OR FAILURE TO USE
ONLY LOGS SPECIFICALLY APPROVED WITH THIS APPLIANCE MAY RESULT IN PROPERTY
LOGS MUST BE PLACED IN THEIR EXACT LOCATION IN THE APPLIANCE. DO NOT MODIFY THE
PROPER LOG POSITIONS, SINCE APPLIANCE MAY NOT FUNCTION PROPERLY AND DELAYED
THE LOGS ARE FRAGILE AND SHOULD BE HANDLED WITH CARE.
PHAZER TM logs and glowing embers exclusive to Napoleon, provide a unique and realistic glowing effect that is
different in every installation. Take the time to carefully position the glowing embers for a maximum glowing effect.
Log colours may vary. During the initial use of the appliance, the colours will become more uniform as colour
pigments burn in during the heat activated curing process.
A. Place the rear log (W135-0620) fi rmly onto the
two studs located at the rear of the support
tray. Ensure the log sits fl at and does not
cover the pilot opening. Place two pins in
holes located on the top of the rear log.
B
C. Place the right log (W135-0545) onto the two
studs located on the right side of the log
support.
D
B
WARNING
!
DAMAGE OR PERSONAL INJURY.
IGNITION MAY OCCUR.
PINS
A
PIN
A
C
E
A
C
PIN
A
B
B. Place the left log (W135-0544) onto the two
studs located on the left side of the log support.
D
A
B
D. Place the left crossover log (W135-0546) onto
the pin located in the left side of the rear log,
allow it to rest in the notch of the left log.
E. Place the right crossover log (W135-0547)
onto the pin located in the right side of the
rear log, allow it to rest in the notch of the
right log.
F. Reinstall the door and safety screen, refer to
the video tutorial or your installation manual
for installation instructions.
76.1A
C
W415-1293 / D / 09.12.16
45
EN