Airwell MFH Serie Manuel D'utilisation Et D'installation page 18

Foam seal A
(adhesive type)
C
Window stool
Window stool
Foam seal
INSTALLATION INSTRUCTIONS(optional)
Installation in a double-hung sash
window
1. Cut the foam seal(adhesive type) to the proper length and
attach it to the window stool. Fig.8
2. Attach the window slider kit to the window stool. Adjust the
Fig.8
length of the window slider kit according to the width of
window, shorten the adjustable window kit if the width of
window is less than 26.5 (Type I) or 22.1 (Type II) inches
Open the window sash and place the window slider kit on
the window stool. Fig.9
Window kit
3. Cut the foam seal(adhesive type) to the proper length
and attach it on the top of the window. Shown as in Fig.10
4. Close the window sash securely against the window.
Fig.9
5. Cut the foam seal to an appropriate length and seal the
Window kit
Type I
Type II
Fig.10
Fig.11
open gap between the top window sash and outer window
sash. Shown as in Fig.11.
C
26.5 ~ 48.0
22.1 ~ 38.6