Adjusting Oven Thermostat Temperature; Service Tones And Codes - Amana EvenAir ZRRC8000 Serie Mode D'emploi

Adjusting Oven Thermostat Temperature

Oven temperature has been factory calibrated and tested.
In unlikely event that oven consistently overcooks or
undercooks food, oven temperature can be adjusted.
1. Press BAKE pad.
2. Press until an oven temperature greater than
+
500°F shows in display.
3. Immediately press and hold BAKE pad until "00"
appears in display, approximately 5 seconds.
4. To decrease oven temperature (for cooler oven), press
until negative numbers appear.
-
Oven can be adjusted from -05° to -35° lower. To avoid
over-adjusting oven move temperature -5° each time.
5. To increase oven temperature (for a warmer oven)
press until positive number appear. Oven can be
+
set from 05° to 35° higher. To avoid over adjusting
oven, move temperature 5° each time.
6. Press OVEN CANCEL pad. Temperature adjustment
will be retained even through a power failure.

Service Tones and Codes

Electronic range control has a self-diagnostic system.
Self-diagnostic system sounds a series of short, rapid
beeps and shows an "F-code" in display when there is a
problem. When electronic range control signals a
problem, follow steps listed below.
1. Record "F-code" shown.
• F1—control malfunction.
• F2—high oven temperature.
• F3—open temperature sensor or circuit
malfunction.
• F4—shorted temperature sensor or circuit
malfunction.
• F7—pad malfunction.
• F9—door lock or lock circuit malfunction.
• FF—door circuit malfunction during clean-cycle.
• "DOOR"– door circuit malfunction or oven door
not completely closed.
2. Disconnect electrical supply.
• Pressing OVEN CANCEL pad or disconnecting
electrical supply may eliminate "F-code". If failure
continues, contact an authorized servicer.
3. Contact an authorized servicer to check range.
15