Electronic Oven Control; Electronic Oven Control Options; Special Oven Control Functions - Amana EvenAir ZRRC8000 Serie Mode D'emploi

Electronic Oven Control

Electronic Oven Control Options

PANEL LIGHT —Used to light backguard and illuminate
cooking surface.
OVEN LIGHT —Used to light inside of oven. Brightens
oven cavity when oven door is opened or panel switch is
turned on.
MINUTE TIMER —Use to time any kitchen function or
cancel timer.
STOP TIME — Use to set delayed bake and delayed self
clean.
CLOCK — Use to set time of day.
OVEN CANCEL — Cancel any cooking or cleaning
function.
COOK TIME — Use to set timed or delayed cooking.
BAKE — Use to set bake.
INSTA-BROIL — Use to set broil.
CONV BAKE — Use to set convection bake.
CONV — Use to set convection.
CONV BROIL — Use to set convection broil.
CLEAN — Use to set self-clean.
— Use to select temperature or time.
or
-
+
AM
HR
:
PM
CLEAN OVEN
STOP ON TIMER
BAKE

Special Oven Control Functions

Preheat Signal
After setting oven to cook and selecting a temperature,
oven will preheat. When the oven reaches the set
temperature, a 1-second signal will sound.
End-of-Cycle Signal
When a timed cycle is complete, three long signals will
sound. End of cycle signal will continue to sound until
CANCEL is touched .
Child Lockout
This is a safety feature used to prevent children from
accidentally programing oven. It disables electronic oven
control. Touch and hold BAKE and COOK TIME for 5
seconds. "OFF" will display where the temperature
normally appears. To reactivate control, touch and hold
BAKE and COOK TIME for 5 seconds. Child lockout
feature must be reset after a power failure.
12 Hour Automatic Cancel
This is a safety feature that prevents oven from continuing
to operate if it has been left on for over 12-hours. If a
cooking function continues longer that 12-hours without
any options on oven control being touched, this feature
turns oven off. Any time an option is touched, 12-hour
automatic cancel is reset.
Minute timer Signal
When time elapses, minute timer beeps 3 times then
once every 10 seconds. If MINUTE TIMER end-of-cycle
signal is sounding, touch MINUTE TIMER.
Increasing
When setting time and temperature, hold pad to
accelerate rate at which numbers increase or decrease.
Self-diagnostic System
Electronic range control has a self-diagnostic system.
Self-diagnostic system sounds a series of short, rapid
beeps and shows a "F-code" in display when there is a
problem.
10
3 5 0
P
°
R
E
CONV BROIL PRE-
DELAY TIMED BAKE
CLEAN LOCK ON
Pad Speed
or
-
+