Replacing Panel Light Bulb; Removing Storage Drawer; Removing Coil Surface Elements - Amana EvenAir ZRRC8000 Serie Mode D'emploi

Replacing Panel Light Bulb

1. Lift up on front edge of backguard top trim. Flip top
trim towards rear of backguard.
2. Twist fluorescent bulb to remove it from sockets.
CAUTION
Wear gloves to protect hands from accidental bulb
breakage.
Lift

Removing Storage Drawer

1. Slide drawer out until it stops.
2. Grasp drawer sides near back of drawer.
3. Lift up and out.
• Reverse to reinstall.

Removing Coil Surface Elements

To avoid risk of personal injury, do not touch surface
elements or area near elements without checking for
heat. Surface elements may be dark in color even
when hot. Hold hand above surface element to detect
heat before touching. Areas near elements may be
hot enough to burn.
1. Hold hand above surface element to detect heat
before touching. Do not touch if heat is detected.
2. Grasp element at end opposite from receptacle and
lift approximately an inch.
• Element clip holds surface element in place.
3. Pull surface element out of receptacle and set aside.
4. Reverse procedure to reassemble.
S u r fa c e E le m e n t
C lip
23
WARNING
B u r n e r B o w l
R e c e p ta c le