Power Supply - FS INTEL XEON RS7260-V2 Guide De Démarrage Rapide

1. Remove the dummy drive, which comes pre-installed in the drive carrier. Pull out the two
locking clasps on the right outside of the carrier and lift out the dummy drive.
2. Position the drive above the carrier with the PCB side facing down and the connector
end toward the rear of the carrier.
3. Tilt the drive to insert it onto the two posts on the left inside of the carrier.
4. Push the right side of the drive fully into the carrier and allow the two spring locking
clasps to secure the drive.
5. Insert the drive carrier into its bay, keeping the release button on the right. When the
carrier reaches the rear of the bay, the release handle will retract.
6. Push the handle in until it clicks into its locked position.
Installing the Air Shroud
Shrouds
1. Position the air shroud in the chassis as illustrated below.
2. Align the notch on the air shroud with the pin on the expansion card bracket.
3. Slide the pin into the back of the notch.
4. Lower the front of the air shroud over the fan tray, sliding the front notches over the pins on the fan
tray.

Power Supply

The chassis features redundant power supplies. The system will continue to operate if one module
fails. It should be replaced as soon as convenient. The power supply modules are hot-swappable,
meaning they can be changed without powering down the system.
These power supplies are auto-switching capable. This feature enables them to automatically sense
the input voltage and operate at a 100-120v or 180-240v.
20