Power Supply - FS DUAL INTEL XEON RS7260 Guide De Démarrage Rapide

1. Remove the dummy drive, which comes pre-installed in the drive carrier, by removing the screws
securing the dummy drive to the carrier. These screws are not used to mount the actual hard drive.
2. Insert a drive into the carrier with the PCB side facing down and the connector end toward the rear
of the carrier. Align the drive in the carrier so that the screw holes line up. Note that there are holes in
the carrier marked "SATA" to aid in correct installation.
3. Secure the drive to the carrier with four M3 screws included in the chassis accessory box.
4. Insert the drive carrier with the disk drive into its bay, keeping the carrier oriented so that the hard
drive is on the top of the carrier and the release button is on the right side. When the carrier reaches
the rear of the bay, the release handle will retract.
5. Push the handle in until it clicks into its locked position.
Installing the Air Shroud
Shrouds
1. Position the air shroud in the chassis as illustrated below.
2. Align the notch on the air shroud with the pin on the expansion card bracket.
3. Slide the pin into the back of the notch.
4. Lower the front of the air shroud over the fan tray, sliding the front notches over the pins on the fan
tray.

Power Supply

The chassis features redundant power supplies. The system will continue to operate if one module
fails. It should be replaced as soon as convenient. The power supply modules are hot-swappable,
meaning they can be changed without powering down the system.
These power supplies are auto-switching capable. This feature enables them to automatically sense
the input voltage and operate at a 100-120v or 180-240v.
19