FS INTEL XEON RS7260-V2 Guide De Démarrage Rapide page 4

Button/LED
1 Power button
2 UID button/LED
3 Power LED
4 HDD
5
NIC LED
6 Power Fail LED
7 Information LED
Color, Status
Red, solid
Red, blinking at 1Hz
Red, blinking at
0.25Hz
Red, solid, with Power
LED blinking green
Blue and red, blinking
at 10 Hz
Blue, solid
Blue, blinking at 1Hz
Blue, blinking at 2Hz
Blue, blinking at 4Hz
Blue, blinking at 10Hz
with Power LED
blinking green
Description
The main power switch applies or removes primary power
from the power supply to the server but maintains standby
power. Hold for four seconds to force a shut-down.
The unit identification (UID) button turns on or off the blue
light function of the Information LED and a blue LED on the
rear of the chassis. This button can also be used to reset the
BMC.
Steady on – Power on
Blinking at 4Hz – Checking BIOS/BMC integrity
Blinking at 4Hz and "i" LED is blue – BIOS firmware updating
Two blinks at 4Hz, one pause 2Hz and "i" LED blue – BMC
firmware updating
Blinking at 1Hz and "i" LED red – Fault detected
Indicates activity on the hard drive when flashing.
Indicates network activity on LANs when flashing.
Indicates a power supply module has failed.
Alerts operator to several states, as noted in the table
below.
Description
An overheat condition has occurred.
(This may be caused by cable congestion.)
Fan failure, check for an inoperative fan.
Power failure, check for a non-operational power supply.
UID has been activated locally to locate the server in a rack
environment.
UID has been activated using IPMI to locate the server in a
rack environment.
UID has been activated locally to locate the
server in a rack environment.
UID has been activated using the BMC to locate
the server in a rack environment.
BMC is resetting.
BMC is setting factory defaults.
BMC/BIOS firmware is updating.
3