FS INTEL XEON RS7260-V2 Guide De Démarrage Rapide page 29

10. If cross-controller RAID is required, select Enable RAID spanned over VMD Controller.
11. Select specific disks for RAID with an [X].
• RAID0: Select at least two [2 - 24] disks
• RAID1: Select only two disks
• RAID5: Select at least three [3 - 24] disks
• RAID10: Select only four disks
12. Select Strip Size (Default 64KB).
13. Select Create Volume.
14. If another RAID is needed, start again at step 9.
15. Press [F4] to save and reboot.
Troubleshooting
General Technique
If you experience unstable operation or get no boot response, try:
1. With power off, remove all but one DIMM and other added components, such as add-on cards,
from the motherboard. Make sure the motherboard is not shorted to the chassis.
2. Set all jumpers to their default positions.
3. Power up. If the system boots, check for memory errors and add-on card problems.
LE2
FP1
JF1
FP Sensor
JL1
IPMI_LAN USB0/1(3.0)
JUIDB2
COM1
VGA
SXB2
SXB1A
BMC
SXB1B
BIOS1
BMC FW1
JVGA2
JNVI2C4
BMC FW2
BIOS2
LE2
PCH
PWR_On LED
JS1
JS2 JS3
SXB1C
JSD2
JSD1
JGPW4
JGPW3
CPU1
P1_NVMe6 P1_NVMe5
JLAN1
SXB3_1
JRK1
VROC
SXB3_2
BATTERY
SP1
BT1
PW Supply2
JBT1
BIOS
LICENSE
IPMI CODE
SXB3_3
BAR CODE
PSU2 PW Supply1
T-SGPIO3
GPU PWR2 GPU PWR1
JPW4 JPW3
CPU2
JPW2 JPW1
PSU1
28